|
• FAST SETTING TIME: 3 HOURS
• SETS AT ABOVE FREEZING TEMPERATURE
(32°F)
• WILL NOT STAIN PAVERS
HELPS PREVENT
• WEED GROWTH
• ANT HILLS
• EROSION & WEARING AWAY
IDEAL
FOR
• SLOPING AREAS
• AROUND POOLS
• ALL TYPE OF DRIVEWAYS & SIDEWALKS
Polymer
Sand is a unique mixture of polymer binders and a calibrated
sand available in beige or slate
grey. The installation of Polymer Sand is almost
identical
to using regular paver joint sand, except for the application of
water. Once Polymer Sand sets, it becomes very firm and locks between
the paver joints. This firm bond maintains pavers securely in
place, being equally effective on both horizontal and sloped surface.
FOR
USE ON
Polymer Sand is recommended for a variety of uses, including
pool sides, patios, driveways, parking spaces, pavements etc...
Paving stones or slabs have to be installed on drainage bed systems
a maximum of 1 inch (2.5 cm) of either sand or stone dust plus a minimum
of 5 inches (12.5 cm) of crushed stone.
NEVER USE POLYMER SAND WHEN PAVERS ARE INSTALLED ON A CONCRETE
SLAB.
INSTALLATION
Method of application of Polymer Sand for a
NEW
PAVER JOB:
1. Install pavers and compact.
2. Make sure the top of the pavers are dry. Sweep Polymer Sand
in between the paver joints and then compact.
3. Sweep off all excess sand on the paver surface. Insure
Polymer Sand lies 1/8 of an inch below the top of the paver
(repeat
step 2 if necessary).
4. Direct a fine mist of water in the air to dampen all the
Polymer Sand joints. Dampen until there is some water retention
on the
paver joints (30 seconds).
5. Minimize or avoid, if possible, walking on the pavers
for at least 4 hours after the installation of Polymer Sand.
Method of application of Polymer Sand for a
EXISTING
PAVER JOB:
INSTRUCTIONS
1. Pressure wash all the existing paver joint filling material
from the top of the paver to the bottom.
2. Do not combine with any other products (follow steps 2
to 5 of new paver job application).
|
